Yarn Spinner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Overengineered yarn spinner with detachable needle holded by magnets.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 29
- Makes
- 0
- Views
- 261
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Non-printable parts needed:
608 ball bearing (but you can use printed one instead)
8x2mm magnets (6 pcs)
8 mm self adhesive rubber pads (4 pcs)
M3x10 screw with washer
M3 brass insert (if using holder part; holder_no_insert do not need it)
How to assemble
Use soldering iron to insert M3 insert into holder. (skip if using holder_no_insert)
Insert holder in ball bearing, place on base (remember that notches between two parts must align) and screw them thight from the bottom of the base.
Glue 3 magnets in rotor and 3 in needle. (polarity!)
Press fit rotor with base.
Finally put rubber pads underneath the base.