V-shape LED aluminium profile endcap and mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2-piece model alows mounting of 45° V-shape aluminium profile LED cooler and capping the end
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 60
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Two-piece model, four part for mounting one Al profile. Desined for M3 tapered screws, works with flat head screws with head diameter less than 6,3 mm.
Printig orientation
Endcap: Lay it flat.
Left/right mounting piece: Best is to set longest part to z axis and have continuous lines through shoulder. Brim is helpfull for bed adhesion.
Assambly
2 sets of tapered hed screws and corresponding nuts (or plastic anchor or similar) per one profile
Put wires for LED strip through endcap and put them in the ends of V-profile, then insert mounting piece in endcap slots. After fixing one side with screw apply gentle pressure on whole assample to emininate tendencies of endcaps slipping out and reasonebly tihgten second screw.
Models
Endcap
Endcap with hole for cables
Left and Right mounting piece with middle hole
Left and Right mounting piece for 15 mm extrusions (screw hole shifted)
Mine are instaled on Voron 0.2, printed from black ABS-T. Printer settings and precission depends a lot.