Suunto Vertical 2 Case REMIX
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reinforced Suunto Vertical 2 bumper. Modified clips for better durability. Print in PETG with focus on layer adhesion.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 23
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a modified version of a protective bumper for the Suunto Vertical 2. While I loved the original design I found on MakerWorld, I noticed that the small clips holding the bumper to the watch were a bit fragile and tended to break after 1-2 uses.
Improvements
Reinforced Clips: I modified the mounting mechanism to be thicker and more robust.
Increased Durability: The bumper now stays securely on the watch even during active use without snapping off.
Print Settings & Recommendations
To get the best results and ensure the clips don't snap, please follow these guidelines:
Material: PETG is highly recommended. It offers the necessary flexibility to "click" onto the watch while being durable enough for outdoor use. (PLA is too brittle for this design).
Layer Adhesion: This is the most important factor. Make sure to print at a slightly higher temperature or lower fan speed to ensure the layers bond perfectly. This prevents the clips from shearing off along the layer lines.
Infill: 100% (it's a small part, so solid is best).
Supports: Depending on your printer's bridging capabilities, minimal supports might be needed for the clip areas.
Credits
This model is a remix of a design originally found on MakerWorld. I have optimized the structural integrity for better long-term use.