M16x1.5 Blind Stuffing + Nut and TPU-Sealing / M16x1.5 Blindstopfen + Mutter und TPU-Dichtung
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
M16 blind stuffing to close unused openings for PG9 cable gland in housings (ca 16.0mm). Optional TPU-sealing available.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 238
- Makes
- 1
- Views
- 432
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
M16x1.5 threaded blind stuffing to close unused M16-openings in housings.
Unused PG9-openings or PG11-openings in housings are also possible to close with this blind-stuffing set, but it is necessary to widen the opening in some cases (see details below).
[1] Thread type:
Metric tread
[2] Diameters for suitable openings:
Diameters for M16x1.5 opening:
a) threaded hole: 14.5mm / M16x1.5 thread
b) drill hole without thread: 16.0mm / no thread
Diameters for PG9 opening:
a) threaded hole: 13.9mm / PG thread -> Requires widening to 16.0 mm diameter.
b) drill hole without thread: >15.2mm / no thread -> Might require widening to 16.0 mm diameter.
c) For a PG9-opening you can also use
https://www.printables.com/model/1478855-pg9-blind-stuffing-nut-and-tpu-sealing-pg9-blindst
as alternative.
Diameters for PG11 opening:
a) threaded hole: 17.3mm / PG thread
b) drill hole without thread: >18.6mm / no thread
c) For a PG11-opening you can also use
https://www.printables.com/model/1483396-pg11-blind-stuffing-nut-and-tpu-sealing-pg11-blind
as alternative .
[3] Sealing:
An optional TPU-sealing model file is available.
Print
Material: PETG (blind stuffing, nut), TPU 95A (sealing)
Supports: not required
Brim: not required
Serial printing (part by part) for better thread quality.
Assembly
Threaded opening:
Screw the blind stuffing into the M16x1.5 opening.
Optionally place sealing on stuffing before assembly.
Unthreaded opening:
Place blind stuffing in PG9/PG11/M16 opening and secure with M16x1.5 nut.
If necessary, widen the opening to >=16.0mm before assembly.
Optionally place sealing on stuffing before assembly.
Use a 1€ coin for turning of the blind stuffing.
Hint:
Apply some silicone grease on the thread, so it can be easily be assembled and disassembled.
(Without grease, the thread tends to wind on and off somewhat “sticky”.)