Shelly Plus RGBW PM Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enclosure for a single Shelly Plus RGBW PM and a few Wago 221s
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 130
- Makes
- 1
- Views
- 573
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
This enclosure is designed to hold:
1x Shelly Plus RGBW PM
1x Wago 221-412
1x Wago 221-413
If you want to use machine screws, you will need (M3 or M4 may work but I didn't check):
8x 6-32 heat set inserts
8x 1" 6-32 screws
You could also probably use some coarse-threaded wood screws instead of the machine screws (if you're some kind of barbarian)
The inserts for the cable clamps are put in from the bottom so they will hold well in case you need to really crank down on the screws.
The Shelly needs to be slid in rather than pushed straight down, as that will probably break the retaining clip.
Wago 221's have a small lip on the bottom by the cable hole. You hook that lip in the bottom then push them against the back retaining clip.
I used these on a project and was able to use a 16-2 AWG cable for the power and 2x 5 conductor RGBW cables.
--
Print settings:
eSun/Inland (Microcenter) PLA+
As fast as my little Creality K1 will go
No supports