MKL SV08 Toolhead Cover - Skeletonized

• SV08 Custom Toolhead cover and BTT Eddy mount.

• Current version: 0.2

Part List:

• 6 - M2.5 Heat set inserts.

• 1 - 5020 Fan (SV08 stock fan works)

• 1 - 2510 Fan.

• 2 - M2.5 x 25MM screws.

• 4 - M2.5 x 12MM screws.

• 3 - 4x3MM magnets (same as stock).

• 2 - 5x3MM magnet.
  

Instructions:

1. Remove built in supports.

2. Insert 6 (2 if not including extra fan) heat set inserts. The one under the fan bracket will need to be inserted at an angle and then straightened.

3. If using the extra fan; insert 2510 Fan and secure with 4 - 12MM M2.5 screws.

4. Insert 5020 Fan and secure with 2 - 25MM M2.5 screws.

5. Insert magnets into toolhead and eddy mount with super glue.

6. Secure eddy / mount with single screw. Make sure alignment bar is flush/horizontal.

7. Tuck fan leads into clip to shorten for connection.

8. Have fun!
   

Instructions Knomi V2:

1. Follow applicable previous instructions.

2. Clip in Knomi.

3. Have fun!

Klipper Configuration:

1. Probe offsets:

   • x_offset=-22

   • y_offset=10

   • z_offset=2.7

2. Extra Fan

   [heater_fan toolhead_fan]      
   pin: extra_mcu:PB0   
   max_power: 1.0               
   kick_start_time: 0.5         
   heater: extruder             
   heater_temp: 45

Print Notes:

• Print slow and steady for the best quality. No faster than 100mm/s.

• Disable "Detect Thin Walls".

• Remove built in supports after printing.

• All parts should be printed in high temp filament. Tested in PETG/ABS.