1 / 10
7x6 sealed beam housing for Morimoto MLED 2.0 — image 1
1 / 10

7x6 sealed beam housing for Morimoto MLED 2.0

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

I designed these so that I could put the MLED 2.0 projector in my MK3 Supra

Rating
0 / 5
Likes
6
Downloads
28
Makes
0
Views
254
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Public Domain

M4 screw set, comes in handy for other things too like the 4 retention screws for the headlight trim and they are used for the projector: https://www.amazon.com/dp/B0DCVVSGW2?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

M4 square nuts, my design uses these in the front housing to hold the porjector in place: https://www.amazon.com/dp/B0DXP8H268?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Cheap headlights you can bake apart for the glass lenses (glass is better; if you don't want weird patterns, make sure the glass has no lines or patterns).  These have 2 horizontal lines and create a small shadow directly in front of your car on the ground; you can't see it unless you approach a wall, but it's something to be aware of: https://www.amazon.com/dp/B0162YN8FG?ref=ppx_yo2ov_dt_b_fed_asin_title

Projectors, be sure to get a roll of butyl (retrorubber) too: https://www.theretrofitsource.com/bi-led-morimoto-m-led-2-headlight-projectors-P-M-LED2?quantity=1

Print in ASA as the files sit, all but the MLED2.0 STLs are designed to print with no supports. In the lens housing, you will notice a 0.2mm solid layer above the square nut hole. This is done to force bridging; it is easily pushed through and requires no cleanup.
I recommend a 10mm outside brim on the lens housing and the rear housing to prevent warping, especially the lens housing, as ASA tends to warp with thin square prices.  I did 20% gyroid infill and archimedean chords for the bottom and aligned rectilinear for the top (top and bottom were done for personal preference, gyroid was done for strength in all directions).

Things that need to get trimmed on the car:
- Any of the fiberglass that is directly behind the bucket that the headlight sits in.  It's not much and takes about 20 minutes to do both with a small saw blade (see photo marked in red)
- Take a grinder and cut the headlight up position stopper bracket from the middle of the hole in an angled line to where the headlight down position stopper is (see photo marked in red)

These fit my car perfectly with about 2mm of clearance when off and folded down.  Currently testing long-term use of these in printed housing, may look into getting a CNC machine to make these out of aluminum.

Video of me driving around with them: 

Tags