Gaggia Classic Switch Bank Mod
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Switch Bank mod for switches with 12mm screw thread. Can be embellished with an iron plate as an option.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 35
- Makes
- 0
- Views
- 431
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This switch bank mod can be used with or without an additional iron plate.
The holes for the switches are 12mm in size.
How to print:
To print, position as shown in the image. Activate brim and support.
Material should be heat-resistant and non-flammable. (Don't use PLA)
Optional metal plate:
Templates for cutting the iron plate are available with the original hole size and with small holes to mark the center point.
In general, it is recommended to cut the iron plate slightly larger to cover the plastic better.
I cut a stainless steel plate with a thickness of 0.5 mm and drilled the holes with a cutting drill bit.
If, like me, you don't have a laser cutter, I recommend using thicker plates, as these are easier to work with using a saw and drill than thin ones.
Wiring
This is intended as an example only and is not a guide; wiring should only be carried out by authorized personnel.
Please note that there may no longer be a conductive connection to the rest of the housing, so you must add another protective (grounding) conductor!
For the rest of the wiring, please check your logic carefully.
(With the GaggiMate mod, not much had to be changed, just one connection, insulating exposed areas and adding another protective (grounding) conductor.)