Warhammer 40k thin / flexible objective markers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I didn't like objective markers I found elsewere, because I think they're too thick. These are very thin and flexible.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 125
- Makes
- 0
- Views
- 331
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Miniature Gaming Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't like objective markers I found elsewere, because I think they're too thick. These are very thin and flexible, and still strong enough. Hardly cost any material and print in +-35 minutes on a 0.4 mm nozzle. So no problem if one is worn out or something.
Nine markers total: 1 unnumbered and 8 numbered from 1-8.
40mm inner diameter + 3" outer diameter = 7.57 inch / 19.24 cm total width.
0.4mm thick, so print it on 0.2 layer height, which gets you 2 layers total.
Print the numbered versions upside-down!
That way you get the smooth side up, and the less smooth side down. Which really helps letting it stay in place on a gamemat! So just rotate it 180 degrees in your slicer.
Print settings
0.4 mm nozzle on 0.2 mm layer height.
Please post your makes and let me know in the comments what you think!
