Pterodactyl v2 5"

Frame & Design Features

• Standard 5″ DC motor spacing

• Designed to accommodate the modular speedybee head

• Lightweight geometry with reinforcement in high-stress areas

• NOT intended for hard freestyle and bashing

Printing Recommendations

• Material: PA12 CF, PA6 CF

• Infill: 20–50% (gyroid preferred)

• Layer Height: 0.2mm

• Perimeters: 4–6 walls

• Orientation: evarything should be pre oriented in the 3mf

• Post-Processing: Heat-set inserts m2 OD3.2mm H6mm are recommended but not necessary

• feets and gps mount( that is a facoltative part if you don't use a gps or you use xt60 or a pigtail xt30

I printed it with PA12 CF at 20%infill gyroid, 4 walls. 0.2mm

Hardware Compatibility

• 5″ propellers

• Standard FPV motors

• 4/6S LiPo battery

• FPV stack mounting patterns 25.5×25.5 (F405 AIO)

• Spedybee modular head

My setup

• 51433 propellers

• iFlight XING E Pro 2207 2450KV 4S

• SpeedyBee F405 AIO 40A Bluejay 25.5x25.5

• SpeedyBee Nano 2.4GHz

• 4s 850,930,1550,1850mah

• Speedybee modular head

• O4 pro

Notes

• This is an experimental frame; flight characteristics depend heavily on print quality, material choice, and tuning.

• Not intended for high-impact racing environments.

Contact me for info, ideas or campatibility problems

I'll add more info and a building guide soon