Nerf Stryfe low profile extended battery door (for Worker collapsible L-shaped folding stock)

This is a basic extended battery door for the Nerf Stryfe, based on the one designed by Tarik that Out Of Darts sells. I found that the OOD version didn't allow for the Worker collapsible L-shaped folding stock to fold completely flat against the side of the Stryfe. My setup uses a Graphine 950mAh 7.4v 2s LiPo battery, and this door allows for just enough room for the battery and leads while still letting the stock fold completely. I have not tested this door with any other batteries, so your milage may vary. One thing to note is that the stock can fold completely with the butt extended in the three longest positions, but the fourth, shortest position cannot fold completely flat, as shown in the photos.

The .stl file should already be in the correct orientation for printing. Alternatively, you could print the door upside-down in order to use (much) less support material, potentially at the cost of print quality (the build plate will be up against the top/outside of the door). You WILL need supports either way.