Eddy Probe Holder for Vzbot Printhead
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted to use the Vzbot Printhead and I had a Eddy Probe already with me so I created a holder for the printhead.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 59
- Makes
- 0
- Views
- 212
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution
I wanted to use the Vzbot Printhead and I had a Eddy Probe already with me so I created a holder for the printhead.
There are two versions one very close to the fan (which is the one I'm using) since the fan 3010 is just attached to the Heat Sink I can slightly move it to the side to fit the probe. However, If you are installing a fan that is attached to the head then it might be too tight so I have created another one that moves the probe to the right by 3mm.
These offset are for the one I'm using so you should add 3mm extra for the X offset.
x_offset: 22
y_offset: -18