soap dispenser/pump & sponge dripping rack
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
just a lil soap dispenser / sponge dripping rack i drew up.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 8
- Makes
- 0
- Views
- 91
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
works with soap dispensers of up to 75 mm diameter and sponges with roughly 70 x 45 mm.
i would suggest to manually place 2 support enforcers in the square corners where the extruded overhangs aren't going in a straight line but around the corner (see last image).
also needed to print about 4x of the feet i uploaded. maybe 3 would work, but rather use 4 as it's more stable.
just glue them somewhere in to the slots with some superglue.
it's not parametric or clean or anything but i threw in the step file so maybe you can adjust some measurements without messing the model up too much lol