IKEA FLISAT Clip-On Hooks for Jackets + Anti-Drop Guard for Hats/Gloves
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kid-friendly clip-on hooks for IKEA FLISAT: hang jackets and keep hats/gloves from falling out.
- Rating
- 5 / 5
- Likes
- 9
- Downloads
- 22
- Makes
- 2
- Views
- 174
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These clip-on hooks turn the IKEA FLISAT wall storage into a neat little kids’ entry station: jackets go on the hooks, while hats, gloves and small items can sit on top without sliding out so easily.
Features
Clip-on design: no screws, no glue, no permanent changes
Dual purpose: Works as coat hook and as a front guard at the same time
Great for kids’ rooms, entryways, daycare corners, etc.
How it works
Unscrew the front rod from the FLISAT
Put the clips onto the front rod
Screw the front rod back onto the FLISAT
Printing tips (general)
PLA works for light kids jackets; PETG is better for toughness
Increase perimeters/infill if you expect heavier loads
I used
Material: PLA
Perimeters: 6
Infill: 20%
Fit note (important)
FLISAT rods aren’t always the same thickness along the length. The clip opening is sized so it can pass the thickest section (at least on my FLISAT). That means it may feel a bit looser on thinner sections depending on your unit and printer tolerances.