Stackable Woodworking Setup Spacer Blocks (Standard)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I had planned to just print a simple setup block that I saw someone use in a YouTube video. It was 1"x2"x3" and seemed handy to have around. As I started modeling it up in Onshape, I decided some other sizes would be useful as well.... but THEN, I decided to make them stackable for easy storage. (Ain't gonna lie--there were some challenges, as I worked to dial-in the exact snug fit I was going for, but also not so tight that other tools were needed to get them apart, which wouldn't be very useful/helpful at all.)
This set will give you quick and easy access to the following (12) measurements:
3 in, 2.75 in, 2.5 in, 2.25 in,
2 in, 1.75 in, 1.5 in, 1.25 in,
1in, 0.75 in, 0.5 in, 0.25 in.
Oh, You can also use the push-holes as simple templates to draw 1in, 3/4 in, and 1/2 in circles on a surface.
I printed them using a light-color filament and then colored-in the recessed measurements with a black permanent fine tip marker. If you prefer NOT to have the measurements recessed (0.5mm recess), I also included a set of .stl models that are unlabeled, so you can just write the measurements on them.
If you want me to make a similar version in metric sizes, please comment below. If I get enough comments, I'll probably get inspired to do that as well.