ADJ Hexbar Wall Spacer – Consistent Uplighting

This spacer is designed to consistently space ADJ Hexbar fixtures off a wall for clean, repeatable theatrical uplighting.

The spacer indexes directly into the factory holes in the Hexbar feet, using alignment pins to lock each fixture into the same position every time. This removes guesswork, keeps fixtures straight, and ensures uniform spacing across an entire run of lights.

I modeled optional screw holes for permanent installs, but in real-world use I’ve successfully mounted these using high-quality double-sided tape, which keeps the spacers secure laterally while still allowing easy removal.

In the photos shown, every Hexbar is using this spacer, with each fixture set at a consistent 5° upward angle toward the wall, producing an even, professional wash with no hot spots or uneven gaps.

Features

• Designed specifically for ADJ Hexbar fixtures

• Consistent wall offset for uniform uplighting

• Alignment pins lock into Hexbar feet holes

• Optional screw holes for permanent installs

• Works well with strong double-sided tape for temporary setups

• Ideal for theatrical, architectural, and event lighting

Printing Notes

• Prints easily with no supports

• PLA works fine for indoor use; PETG recommended for higher heat environments

If you’re tired of eyeballing spacing or fighting uneven uplighting, this spacer makes Hexbar installs faster, cleaner, and repeatable.