1 / 2
Spring loaded engraver bit for ER16 collet (ER11 to ER16 remix) — image 1
1 / 2

Spring loaded engraver bit for ER16 collet (ER11 to ER16 remix)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

ER16 remix of the original spring-loaded PCB solder mask engraver bit (ported from ER11 to ER16).

Rating
0 / 5
Likes
2
Downloads
13
Makes
0
Views
143
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Share Alike

Description

This is a remix of “Spring loaded engraver bit for ER11 collet” by dulouie, adapted to be clamped in an ER16 collet.

Purpose: PCB solder mask engraving / opening with a spring-loaded mechanism that adds compliance and helps reduce the risk of cutting into copper when Z isn’t perfectly consistent.

What changed in this remix

  • ER11 to ER16 interface conversion for compatibility with ER16 spindles/collets.

  • No functional change besides the collet interface: same spring-loaded concept as the original.

Printing recommendations

  • Material (recommended): PC-ABS (best for heat resistance and clamping strength).

  • Wall/perimeters: 4–6

  • Infill: high (≥30%)

  • Supports required: use Tree supports (recommended) due to the geometry (overhang features).

  • Avoid PLA (softening/creep risk under heat and clamping load).

Hardware / tool

  • Typically used with a 60° V-bit for solder mask engraving (same as the original concept).

  • Spring and hardware follow the original model’s approach.

Safety notes

  • This is a printed part used in a rotating tool: start at low RPM, verify clamping, runout and balance.

  • Eye protection strongly recommended.

Original model credit: dulouie ✅

Tags