1 / 3
Oculus Quest Anker 13000 battery mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Rear battery mount for the Anker PowerCore 13000 battery, and helps take some of the Quests weight off the face.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 135
- Makes
- 0
- Views
- 1,583
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial
Rear battery mount for the Anker PowerCore 13000 battery, and helps take some of the Quests weight off the face.
Print instructions
Print bottom side down, break off support tabs around inside zip tie slot and battery indicator.
I printed at 0.3mm, 10% infill.
Uses 3 pieces of 20mm wide by 1.5mm thick velcro, and an optional ~12" zip tie.
It's a tight fit on my battery, and my print settings, so I opted not to use the zip tie in the end.
- I've added a no-ziptie version, but YMMV for battery fit, so if in doubt, use the ziptie one instead.