1 / 6
Gens Ace iMars D300 / Dual Charger Angled Stand — image 1
1 / 6

Gens Ace iMars D300 / Dual Charger Angled Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

License
GNU General Public License v3.0

This is a support-free, airflow-optimized angled stand designed specifically for the Gens Ace iMars D300 Charger and also compatible with the older iMars Dual model.

The stand holds the charger at a 40° viewing angle, making the screen easy to read while charging — ideal for bench use, pit tables, or on-track setups.

Key Features

  • 40° viewing angle: Optimized for clear screen visibility during charging and setup.

  • Support-free print design: All geometry is engineered with printable angles, arches, and ribs — no supports required.

  • Minimal rear material for airflow: The back of the stand is intentionally open to maximize airflow and avoid heat buildup.

  • Does not block ports or fans: All connection ports, side vents, and cooling fans remain fully unobstructed.

  • Sturdy and track-ready: Reinforced side frames and triangular geometry provide excellent rigidity for on-track use.

  • Lightweight but strong: Uses material only where needed, reducing print time while maintaining strength.

  • Charger-specific fit: Designed to securely cradle the Gens Ace iMars D300 and iMars Dual chargers without wobble.

Print Recommendations

  • Material: PETG recommended (PLA also works for indoor or shaded areas)

  • Layer Height: 0.28mm, you can do 0.20 if you care about smoothness

  • Supports: Not required except for brim ears on the corners to prevent warping

  • Orientation: Print flat on the build plate as shown

  • Infill: 10% (gyroid)

  • Walls: 2. You can add walls for extra rigidity, but the model is already very sturdy

Tags