1 / 6
Gens Ace iMars D300 / Dual Charger Angled Stand — zdjęcie 1
1 / 6

Gens Ace iMars D300 / Dual Charger Angled Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
GNU General Public License v3.0

This is a support-free, airflow-optimized angled stand designed specifically for the Gens Ace iMars D300 Charger and also compatible with the older iMars Dual model.

The stand holds the charger at a 40° viewing angle, making the screen easy to read while charging — ideal for bench use, pit tables, or on-track setups.

Key Features

  • 40° viewing angle: Optimized for clear screen visibility during charging and setup.

  • Support-free print design: All geometry is engineered with printable angles, arches, and ribs — no supports required.

  • Minimal rear material for airflow: The back of the stand is intentionally open to maximize airflow and avoid heat buildup.

  • Does not block ports or fans: All connection ports, side vents, and cooling fans remain fully unobstructed.

  • Sturdy and track-ready: Reinforced side frames and triangular geometry provide excellent rigidity for on-track use.

  • Lightweight but strong: Uses material only where needed, reducing print time while maintaining strength.

  • Charger-specific fit: Designed to securely cradle the Gens Ace iMars D300 and iMars Dual chargers without wobble.

Print Recommendations

  • Material: PETG recommended (PLA also works for indoor or shaded areas)

  • Layer Height: 0.28mm, you can do 0.20 if you care about smoothness

  • Supports: Not required except for brim ears on the corners to prevent warping

  • Orientation: Print flat on the build plate as shown

  • Infill: 10% (gyroid)

  • Walls: 2. You can add walls for extra rigidity, but the model is already very sturdy

Tagi