1 / 3
Pmod I2S2 case
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Case for Digilent Pmod I2S2, uses two M2.5 screws and nuts. No supports needed, will probably print fine with whatever filament/layer height you feel like using. Note that the pins are slightly recessed into the case, so depending on the board you're connecting it to, you may or may not need to use an extension cable instead of plugging it in directly.
Shown in the second picture with this model: