1 / 1
BOSS RC-20XL Looper Pedal backplate
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
add backplate over rubber to velcro to pedal board
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 10
- Makes
- 0
- Views
- 38
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Increased size quite a bit. It it tight on the back with the rubber and the screws pull it in. Start the 4 corner screws loosely, then tighten progressively. Print in PETG or PLA (if it will not be exposed to high heat like in a vehicle in summer otherwise use PETG). Printed with supports for the screw holes.