Kia Rio Door Mount for BOZ / Hydro Flask Bottles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Clip-on door cup holder for Kia Rio 2013. Fits large 91mm bottles (BOZ/Hydro Flask). Allows door to close fully.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 19
- Makes
- 0
- Views
- 135
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
This is a custom-designed cup holder adapter for the 2013 Kia Rio, specifically for the front passenger door.
If you have a large water bottle (like the BOZ brand, Hydro Flask, or Nalgene), you know they never fit in the standard center console cup holders. My wife’s bottle was constantly rolling around on the floor mats, which is annoying and potentially dangerous while driving.
The Solution I designed this holder to clip securely onto the passenger door storage pocket. It creates a stable, dedicated spot for large diameter bottles (approx 91mm).
Features
Clip-On Design: No screws, glue, or permanent modifications required. It clips onto the existing door geometry.
Full Door Functionality: Designed with clearance in mind—you can open and close the passenger door completely without the holder hitting the seat or dashboard.
Large Capacity: Fits bottles with a diameter up to ~91mm (Tested with BOZ brand).
Secure Fit: Deep enough to keep the bottle upright during turns and braking.
Print Settings (CRITICAL)
Material: PETG, ASA, or ABS is highly recommended. Do NOT use standard PLA. The inside of a car can easily reach 60°C+ (140°F+) in the summer, which will cause a PLA print to warp and fail.
Walls/Perimeters: 3-4 walls for structural rigidity.
Infill: 20% Gyroid or Honeycomb.
Supports: required for the clip section that goes over the door panel.
Installation Simply slide the clip over the edge of the passenger door storage bin. Press down until fully seated.
Drive safe and stay hydrated!