Cowbell with Handle and Clapper printed with PPS-CF10

I was looking for a demonstration vehicle to try the 350C hotend on the new Elegoo Centauri Carbon 2. I wanted to try the new Polymaker PPS-CF10. Jsmaz3 made a fantastic handbell model ( Make of PPS-CF10 Bell by Simple3D | Download free STL model | Printables.com ), but it takes a lot of filament. I wanted to make something with less fillament and louder. I was curious about how annealing would change the metalic tone.  Cowbells are simple construction and good noise makers. 

I printed the cowbell and clapper with PPS-CF10 with 100% infill. The handle was printed with wood PLA

Listen to the sound before / after annealing:

• Cow Bell 3D printed with PPS-CF10 before annealing

• Cow Bell printed with PPS-CF10 after Annealing

I annealed the parts for 12 hours at approximately 125C in an old oven.

Things I used:

• Polymaker PPS-CF10 ( https://amzn.to/4aqm2Gs )

• Elegoo PLA wood ( https://amzn.to/4tr3AVY )

• 2mm Heat Inserts ( https://amzn.to/3ZI8U9x )

• 2mm bolts ( https://amzn.to/3ZNTksY )

• Heat Insert tool ( https://amzn.to/46cHrAw )

• Hex drivers ( https://amzn.to/45FTiHa )

• cowbell ( https://amzn.to/49TkB3n )

FTC Disclaimer: We may earn commissions for purchases made through the links above. As Amazon Associates we earn from qualifying purchases