1 / 2
Profile for Creality K2Pro (OrcaSlicer) for PETG. — image 1
1 / 2

Profile for Creality K2Pro (OrcaSlicer) for PETG.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Profile for Creality K2Pro (OrcaSlicer) for PETG.

Rating
0 / 5
Likes
9
Downloads
142
Makes
0
Views
404
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I wasn’t satisfied with the results using the stock Creality profile, so after dozens of hours of calibration, I’ve implemented my own tweaks. The print quality has significantly improved.

I have also switched from CrealityPrint to OrcaSlicer (v2.3.1) because it offers a much wider range of settings and control.

Important: This profile is intended for firmware version CR0CN200400C10_ota_img_V1.1.3.6 and later. If you are on an older version, you must manually disable "Arc Fitting" as it is not supported. Also, this is designed specifically for high-flow nozzles.

Make sure to perform a thorough manual calibration of your K2 Pro (Temperature, Bed Level, Flow Rate, and Pressure Advance). I strongly advise against relying on automated calibration, as it lacks the necessary precision.

You can use these settings as a baseline, but keep in mind that you’ll need to fine-tune them based on your specific nozzle, ambient room temperature, filament type, and even the pigment (color) of the plastic. All of these factors affect the final result.

For the test that you see in the photo, I used a 8 cm high model with a 0.2 mm layer height.
https://www.printables.com/model/1192499-astronaut

I will continue to update this profile as I find further optimizations.

//24.02.2026//
- It is enabled to avoid crossing walls.

//26.02.2026//
In the Arachne perimeter generator, the "Minimum perimeter width" parameter has been fixed from 85% to 40%. This makes it possible to print small details with fine detail. Within reasonable limits, no thinner than 0.16 mm

There is also a profile for PLA:

Tags