Icom 2100H ham radio speaker gasket, original and thin variant for thicker speakers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printable replacement TPU spacer between the radio and the speaker, and a redesigned thin version for thicker speakers.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 42
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- BSD License
When replacing the broken speaker on my Icom 2100H, the replacement speaker was slightly thicker than the original, such that the speaker and case didn't fit cleanly in place. I duplicated the original design precisely, then made a modified version allowing 1.8mm more clearance to fit the new thicker speaker.
Both the original and revised versions are included. Print with TPU (I used Sainsmart 95A TPU).
The thin version is confirmed to work with the Soberton WSP-5708, and you'll want to use a 2-pin JST-ZH (1.5mm spacing) connector.