1 / 2
Ender 3 V3 KE - Top Light Mount for IKEA Strimsäv — image 1
1 / 2

Ender 3 V3 KE - Top Light Mount for IKEA Strimsäv

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a simple mounting point for IKEA Strimsäv spotlight that snaps on the top of the gantry.

Rating
0 / 5
Likes
2
Downloads
11
Makes
0
Views
78
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Carefully attach the mount on the gantry as seen in the photos. You will feel resistance, and the intended print orientation puts the teeth at a weak point; but the model is thick enough that it won't snap if your print settings are good (see below). Then push the cable into the cable channel, and slide the light's connector into place.

It fits snug enough to not rattle, but there's still enough tolerance to move it left and right. You also need to route the cable through somewhere down to the Nebula Pad so it doesn't touch the belt or lead screw; I attached mine to the gantry support I had installed. 

Due to the shape of the teeth, you probably can't take it off without breaking it. You might be able to use a more flexible material PETG or even TPU.

I uploaded two versions of the model;

  • SinglePiece is the one I use, prints in a single piece and in a vertical orientation to keep the cable channel free of supports. You will have to support the floating tooth, and the mount could theoretically snap along the layer lines while you're pushing it down, but I haven't had any problems in practice.

  • I haven't even tested TwoPiece, but the teeth should be much more durable due to the print orientation, and the part that takes the connector is free of supports. You print them both in the original orientation and glue them together. You still need to support the cable channel on the teeth. Might be messy.

  • You could also print the SinglePiece in a sideways orientation, but the part that takes the connector will need supports, which will be a bit hard to remove cleanly.

Print settings(& material) I used:

  • eSun PLA+

  • 215 C

  • 3 walls

  • 15% infill

  • 100 mm/s outer wall, ~200 everything else

Tags