Hula Buildplate Holder Bambu Lab H2D H2S H2C – improved
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Buildplate Holder Bambu Lab H2D / H2S / H2C printers with HULA feet.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 122
- Makes
- 0
- Views
- 1,378
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bambu Lab Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I stopped uploading and updating my models here at Printables!
My actual models can be found on my MakerWorld profile – with print profiles.
Take care to use the newest models …
I found a similar model, but it was too complicated, too tight and too deep. So I made my own.
The slots are 1.5mm high, 357mm wide and 332mm deep which allows to grip the plates from the side.
The sides are very wide to fit plates for H2D/H2S and H2C which have different dimensions, even the Vision Encoder fits.
No support needed, no brim needed, but please TAKE CARE OF GOOD BED ADHESION!
If needed only use outer brim.
You do not want to print it twice because it needs a lot of filament.
I highly recommend using my print profile on MakerWorld. It slows down by height and is quite strong with 4 walls and height range modifiers to get the connectors even stronger.
I printed with .24mm layer height. Both parts fit on one plate on H2 printers.
Use (hot) glue and/or 4x16 countersunk screws to assemble the two parts, they are symmetrical.