2440 Motor Water Cooling Jacket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3D printed cooling jacket for your 24mm diameter motor.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 20
- Makes
- 0
- Views
- 196
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
This is a water cooling jacket for a 2440 motor (I designed it around a KingVal 2440 motor.
Make sure that it's oriented correctly, it should print with no supports, If your slicer is adding supports, flip it 180 degrees.
There are 3 included variants, the one pictured is the "linear outlets" variant.
There is also a variant called "Linear Outlets _ Tall Cooling Ports" that has the cooling ports lifted a few mm in case you need to get over a taller mounting bracket.
The 180 degree offset variant has both ports on the same face of the jacket, but oriented 180 degrees.
You will need 2 small 3/8" tubes (either brass or aluminum, lowes or amazon has them.
You could also print a small tube or just put your water cooling line in the holes. ,Whatever floats your boat!