SV08 - A4T Filament Cutter ARM
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Model to use the Crossbow CNC Filament Cutter installed to an A4T with the SV08 and Nadirs @CN3D V2 Gantry
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 18
- Makes
- 0
- Views
- 268
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hey Guys, i am voronizing my Sovol SV08, for this i build the A4T Toolhead with the CNC Crossbow Filament Cutter.
To Use this Cutter, there was no Model for a fitting Depresser Pin to actuate the Filament Cutter.
So here we are, i made it.
It is made to work with Nadir @CN3d Gantry V2
Installation:
Install the Square Nuts into the Arm Holder, make sure your Shrinkage is calibrated, as its a perfect fit.
Remove the 3 M3 Screws, where the Holder will be screwd to.
Insert the Spacers into the 3 M3 Holes on the Gantry, Set the Depresser Arm Holder on Top.
Screw in the M3x35 and if needed use an extra Spacer above the Holder. The Spacer can be scaled in Z as needed and are 5mm tall without Modification.
Loosely Screw in the Depresser Arm, Move the Head to see where the Cutter Aligns. Move the Arm if needed. --> Screw it tight.
There is a Mirrored Depresser Arm File if you use another Y-Movement actuated Filament Cutter and you need another Alignment.
BOM:
3x M3x35 (M3x40 works if used with 3 additional Spacer Pins as seen in the Pics)
2x M3x8
2x M3 Square Nuts
Printsettings:
printed in Flashforge ASA
printed in Standard Voron Settings
Print aligned as shown in the Last Picture
Actuation Area:
X=0 Y=349-->360