Snap fit case/box for Raspberry Pi Camera Module v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick to print case for the Raspberry Pi Camera Module v2.1. Snaps together. GoPro mount compatible. No supports needed.
- Rating
- 5 / 5
- Likes
- 39
- Downloads
- 813
- Makes
- 2
- Views
- 2,708
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a lightweight and easy to print case I designed for the Raspberry Pi Camera Module 2. It snaps together and can be separated again. It has a GoPro compatible mount. No supports are needed for the print. It has successfully been tested with PLA & PETG on a Prusa Mini+. Only needs ~40 mins to print.
Print Instructions
Use the *.3mf file, which includes all necessary print settings:
- Layer height ≤ 0.2 mm
- “Detect thin walls” enabled in print settings
- Gyroid infill
- Print the body and cover with the flat face down
Assembly Instructions
- Connect the camera module with the flat ribbon cable
- Insert the camera module into the housing
- Gently push the module down until it snaps into place
- Attach the cover. Make sure the cover is attached in the correct orientation with the notches facing into the direction of the mount.
Disassembly Instructions
- Lift the cover from the body using the notch at the top of the case
- Gently push the two latches apart and pull the camera upward using the ribbon cable. Don't apply too much force, as this could damage the cable.
Compatibility
Use a accessory with a GoPro compatible mount or design your own (just add a mount like this to your design).
Let me know how it works for you and I' would be happy if you share your results.