1 / 7
Snap-on IKEA LEDBERG light bar for Ender 3 V3 KE/SE (No Supports!) — image 1
1 / 7

Snap-on IKEA LEDBERG light bar for Ender 3 V3 KE/SE (No Supports!)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Snap your IKEA LEDBERG strip light onto your Ender 3 V3 KE or SE and use it as a light bar!

Rating
0 / 5
Likes
5
Downloads
17
Makes
0
Views
271
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Intro

I was sprucing up my Ender and really wanted to add a light bar to it for remote monitoring, but I didn't want to pay for the official Creality one. I hunted through drawers and found an old IKEA LEDBERG light bar. It was the perfect length and had enough brightness for my camera. 

Features

  • Snaps into place on the gantry

  • Can be printed in PLA or PETG

  • Fits in front of the filament sensor and does not need any hardware to install

  • Print and snap into place!

  • Only uses 15-20G of filament per part

  • Removable and fully 3D printed

Installation

Print two copies of the files; they are identical and will fit on either side. Then pull out the wires connecting the LEDBERG to its power supply. Gently, with some carefully applied force, slide the connector onto both ends of the LEDBERG, so they rest between the LEDs (so it doesn't block any of the light out). After this, just snap it onto the gantry of your printer and away you go!

If you have trouble fitting the LEDBERG into it's holder, just get it onto the ends of the light bar and wait a few minutes. If it's made of PLA it will slowly deform to fit, and sliding it along will be much easier!

Note: When fitting the LEDBERG light into its holder, make sure to note which side will clip onto the Ender, or you may end up installing it backwards. Additionally, make sure you slot the LEDBERG with the LEDs facing down into the plastic. You will break the bar if you try to install it the wrong way.

UPDATE: Now compatible with the 90 deg. spool holder mod! (Find the model below!) Just print the extended version of the file, same settings and quantities as above. See the last 2 pics in the carosel for the looks.

Print settings

I printed mine with Navy Blue (and for the extension, black) eSun PLA+, using the following settings:

  • 0.2mm layer height

  • 2 walls

  • 15% infill

If you have any questions or constructive feedback, please feel free to drop it in the comments. If you like what you see, please consider supporting it, it means the world to me :)

Tags