Baby Monitor Angled Support for Shelf
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Aim your camera down from out of your toddlers reach without having to put holes in your wall.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 42
- Makes
- 0
- Views
- 348
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted something I could put my baby monitor on to aim it down from a shelf above where my toddler couldn't reach it. I also didn't want to mount it to a wall and have to repair the holes that would leave.
This was my solution. The camera easily slides onto the two tabs attached to the top surface that is angled down at 35° and stays put.
The two tabs do require a very minimal amount of support to print properly, but this is still a very simple print that takes seconds to remove the support material. It doesn't require much infill either; I printed with 8% infill with a 0.15 mm layer height.