AlorAir HD55S 2x4 Foot Mounting Cradle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cradle to ensure the feet stay on the 2x4
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 20
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
I installed my AlorAir HD55S by hanging 2x4s from a chain in the basement. To ensure that the feet of the dehumidifier never slip off the 2x4 I designed and printed these mounts.
Print Settings
These are not holding any weight so they do not need to be printed super strong. The settings below are what I used, you can modify as you see fit.
Filament: PETG
Perimeters: 3
Infill: 40%
Infill Pattern: Gyroid
Layer Height: 0.3mm
Print Orientation: as saved in file, standing up
Quantity: 4
Installation
I prepared the 2x4s I was going to use by cutting them 3" longer on each side then the width of the dehumidifier. I then installed the lag hooks about 1.5" from the end.
With the dehumidifier on a table I placed one board under each of the feet and then placed the printed parts on the board under the dehumidifier with the cutout for the foot on each mount facing outwards. I adjusted the board so it is centered width wise with the dehumidifier. I then slid the printed mounts towards each foot and marked the position.
With the board removed from under the dehumidifier I pilot drilled and then fastened each mount using 4x #8 wood screws 1.25" long. You should be able to get away with maybe 0.5" long screws, the screws are just making sure the printed parts cannot slide.
Note that the foot spacing is not the same for each side so be sure to do the above procedure for each side and make a note of what 2x4 goes where.
Then I hung to 2x4 from the joists using more lag hooks. To place the dehumidifier on the hanging 2x4s I placed it on my shoulder like a 80s boombox and then positioned the dehumidifier in place. I would recommend getting a helper as this was difficult to do alone.
Step back and enjoy. Maybe take a break.