Mennekes Type 2 cable wall holder for EV car charger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wall holder for Type 2 cable (Mennekes) for car charger
- Rating
- 5 / 5
- Likes
- 43
- Downloads
- 363
- Makes
- 1
- Views
- 1,498
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple wall mounted holder for cable spool and Mennekes Type 2 plug (car side). Model has optional covers for mount holes and also locking clip for cable - so it doesnt slip. Locking clip is "click on" the shaft in the holder.
Print as shown on pictures - supports are needed in arch area (for smooth surface, so cable does not get scratched).
Mount holes are for countersunk screws with 5mm shaft. There are 3 mount holes of oval shape for possible adjustments if Your holes are not leveled.
If You have it exposed in exterior as I do - i suggest using ASA or PETG (I have several structural PETG prints outside for 8 years without any sign of wear)
"Socket" for plug has drain hole - in case water gets in - so it can flow away and not get into connector.
I suggest to sacrifice a bit of material and print it tough enough - so 4-5 perimeters, 20-25% infill and 5 top/down layers as minimum.
************************************************************************************************************
Držák na nabíjecí kable pro elektroauto - typ Mennekes Typ 2.
Montáž na zeď pomocí 3 vrutů se zápustnou hlavou.
Kromě držáku si můžete vytisknout i záslepky na montážní otvory a "zamykací" klips. Klips se nacvakne na osičku v držáku (jde i vycvaknout, ale blbě).
Díra na nabíjecí konektor má na zadní straně odtok - aby se případná voda nemohla držet u konektoru
Doporučuji tisk z ASA nebo PETG - podle toho kde budete mít držák umístěn. 4-5 perimetrů, 20-25% výplň a 5 spodních i vrchních vrstev.