1 / 9
Mennekes Type 2 cable wall holder for EV car charger — zdjęcie 1
1 / 9

Mennekes Type 2 cable wall holder for EV car charger

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall holder for Type 2 cable (Mennekes) for car charger

Ocena
5 / 5
Polubienia
43
Pobrania
352
Wydruki
1
Wyświetlenia
1457
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple wall mounted holder for cable spool and Mennekes Type 2 plug (car side). Model has optional covers for mount holes and also locking clip for cable - so it doesnt slip. Locking clip is "click on" the shaft in the holder.

Print as shown on pictures - supports are needed in arch area (for smooth surface, so cable does not get scratched). 

Mount holes are for countersunk screws with 5mm shaft. There are 3 mount holes of oval shape for possible adjustments if Your holes are not leveled.

If You have it exposed in exterior as I do - i suggest using ASA or PETG (I have several structural PETG prints outside for 8 years without any sign of wear)

"Socket" for plug has drain hole - in case water gets in - so it can flow away and not get into connector.

I suggest to sacrifice a bit of material and print it tough enough - so 4-5 perimeters, 20-25% infill and 5 top/down layers as minimum.

************************************************************************************************************

Držák na nabíjecí kable pro elektroauto - typ Mennekes Typ 2.

Montáž na zeď pomocí 3 vrutů se zápustnou hlavou.

Kromě držáku si můžete vytisknout i záslepky na montážní otvory a "zamykací" klips. Klips se nacvakne na osičku v držáku (jde i vycvaknout, ale blbě).

Díra na nabíjecí konektor má na zadní straně odtok - aby se případná voda nemohla držet u konektoru

Doporučuji tisk z ASA nebo PETG - podle toho kde budete mít držák umístěn. 4-5 perimetrů, 20-25% výplň a 5 spodních i vrchních vrstev. 

Tagi