Qidi Q2 riser nozzle holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
qidi stock riser cap & nozzle holder, closes top hole but still allows for vent to freely open and close
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 33
- Makes
- 0
- Views
- 381
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
noticed the riser cap model on here, when printed right and wedged in, held in rigid enough to double well as some kind of holder, so i caded this up
o.g model: https://www.printables.com/model/1580108-qidi-q2-qidibox-stock-riser-cap
make sure you scale or adjust for shrinkage in slicer, it should wedge in tight and hold firm with little to no wobble.
also add: https://www.printables.com/model/1633105-qidi-q2-riser-locking-cap
in rear hole if you want door to only slide one way open and close
one side has small lip so orient on flattest side for printing with no supports
100% infill
i printed with 0.4 and 0.08 layer height in white abs
most other filaments should work too