Megaboom 3 Protection Holster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Do you like this design and want to give a Tip for it? Do it here About this: Protection Holster was tested. Works…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 10
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you like this design and want to give a Tip for it? Do it here
About this:
Protection Holster was tested. Works fine and sounds great. Should be fine for Boom 3 too, if printed smaller.
STP-Project-File is still a bit messy, so I didn't upload it yet.
The Holster was printed with Semiflex TPU. Handle with PETG.
Materials/Slicing:
Fiberlogy Fiberflex 40D was used for the holster. Seems to be the best price/performance Semiflex-TPU in 2020. 20%-Gyroid-Infill worked fine for me. The Handle was printed in PETG.
You must use the smart seam-hiding-feature in your slicer. Random Seams leads to roughness, which may damage your fabric.
Afterwards/Mounting the handle:
I did use M5x15 countersunk-screws for mounting the handle. I did cut M5-Threads into the handle. Afterwards I did screw the screws in a little to wide to turn them a little back, so the heads sit tight in the tpu and a minimal gap between holster and handle is existant. The M5-Thread will work as a friction bearing.
Print Settings
Printer:
TwoTrees Sapphire Plus with E3D Hemera
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:
Fiberlogy FiberFlex 40D
Burgundy
Notes:
Use Smart-Seam hiding!
Category: Audio