Zooz ZEN58 Surface Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Compact wall/surface mount for the Zooz ZEN58 XS Relay. Features a secure snap-in design with dual clips and side fricti
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 39
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a custom-designed wall/surface mount for the Zooz ZEN58 XS Relay, allowing for a clean, secure, and accessible installation.
The relay snaps firmly into place using dual retention clips, combined with a snug friction fit along the sides. This ensures the device stays securely mounted while still being removable when needed.
Features
Secure snap-in design (no fasteners required for the relay itself)
Dual clip retention + side friction fit
Clean, low-profile mounting solution
Designed specifically for the Zooz ZEN58 XS Relay
Print Settings
Material: PLA or PETG
Supports: Not required
Nozzle: 0.4mm
Layer Height: 0.20mm or 0.16mm (both tested)
Perimeters: Minimum 2 (recommended 4 for strength)
Notes
Printer calibration is important. This model uses tight tolerances to achieve a proper snap fit.
If your fit is too tight or too loose, adjust horizontal expansion or flow accordingly.
PETG is recommended for installations in warmer environments.
Installation
Mount the base to your wall or surface using appropriate screws.
Align the ZEN58 relay with the mount.
Press firmly until the relay snaps into place.
Removal:
Insert a small flat-head screwdriver into the bottom slot and gently use it as a lever. Apply minimal pressure to lift the relay out of the tray/walls holding it in place. Once released from the tray, the relay can be easily removed.