1 / 1
Home Matic Window/Door Sensor cover (HmIP-SWDM/HmIP-SWDM-2) — image 1

Home Matic Window/Door Sensor cover (HmIP-SWDM/HmIP-SWDM-2)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Covers for the HmIP-SWDM and HmIP-SWDM-2 Home Matic Devices

Rating
0 / 5
Likes
2
Downloads
8
Makes
0
Views
63
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The provided .3mf files already contain the settings I was using. If you're using the .stl ones, use the following settings:

Magnet cover:

(Orientation as is; closed on top, open on bottom)

This part replaced the original one.

  • Material: PLA (or whatever you have at hand; ideally none shrinking)

  • Support: No

  • Layer height: 0.2-0.3mm*

  • *Adaptive layer height: starting at 11.2mm of 0.2mm or less for a better finish of the top surface

Main Body:

(Orientation upside down; closed on bottom, open on top)

This parts slips over the original one. Depending on your material, it might be a tight fit. You can heat it up with a lighter and place it on top of the original one.

  • PLA (or whatever you have at hand; ideally none shrinking)

  • Support: No

  • Layer Height: 0.2mm or smaller. The bottom part will be the front of the cover and I would recommend at least 2 layers.

  • Spiral/Vase mode: Yes (Not required but recommended)

  • (I've also increased the print speed of the External perimeter to 100% from the CORE One's default 50%)

Note: The Main Body cover does not include the side chamfer of the original part. This is for easier printing, since it weaned to avoid supports.

Tags