1 / 1
Zendure SolarFlow 800 Fan Shroud — image 1

Zendure SolarFlow 800 Fan Shroud

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Because "rated for outdoor use" and "happy in direct sunlight all day" are two very different things.

Rating
0 / 5
Likes
2
Downloads
32
Makes
0
Views
504
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Hybrid solar devices throttle in summer heat. At maximum load the SolarFlow 800 Pro reaches housing temperatures of up to 63°C indoors at room temperature – outside in direct sunlight it gets worse. This two-piece snap-on shroud sits on top of the SolarFlow 800 Pro, channels airflow via the Venturi effect across the heatsink fins, and keeps temperatures where they belong.

The SolarFlow's built-in fan port delivers temperature-controlled voltage: 7V from ~35°C, rising to 12V at higher temperatures, with up to 0.3A available. A standard 80mm 1.2W fan connects directly – no extra power supply needed.

What you need

  • 1× 80mm PC fan (12V, max 1.5W)

  • 4× fan screws + 1× 80mm fan grille

  • 2× M4×8mm pan-head screws (rear mounting)

  • 1× cable tie for strain relief

  • 1× waterproof M12x1 (I think!) connector for weatherproof connection to the fan port

Installation The two-piece shroud simply lays on top of the device and is secured at the rear with 2× M4×8mm pan-head screws. Mount the 80mm fan with fan screws and grille. Route the cable through the hole and solder M12 connector for a weatherproof outdoor connection. Secure with a cable tie as strain relief.

Compatibility

✅ Zendure SolarFlow 800 Pro (349.7 × 201.7 × 340 mm)
❌ SolarFlow 2400 Pro – different housing (326 × 294 × 251 mm)
❌ SolarFlow 800 / 800 Plus – different form factor

Print settings

  • Material: PETG or ASA (outdoor/UV – PLA will not survive summer)

  • Infill: 15–30%

  • Layer height: 0.2–0.3mm

  • Supports: No

Designed by someone who watched their inverter throttle on a perfect sunny day and decided that was unacceptable.

Thanks to Michael, who reverse engineered the connector.

If you print it, please provide feedback on how tight the latches are - I did tweak the tolerances after my print. Afterwards, I'll update the files here (thus temporarily CC BY-NC-ND 4.0)

Tags