IKEA Lack Removable Plexiglass Joints

I've modified the original IKEA Lack joints to remove each plexiglass individually for printer maintenance.

This is useful if you have couple printers stacked on top of each other and you need to do some maintenance for the bottom one. Instead of removing all the top IKEA Lacks (and printers) to get access to the bottom one, you just remove the plexiglass and get access to the printer from the side.

Also, the PSU wires go through the gap between the plexiglass and the leg, and by removing the plexiglass, you can take the printer with the PSU out of the lack if you need, without lifting the table up.

I've used a 2.8mm diameter, 13mm length screw (shown in the 7th image) for the plexiglass joints. I've included the step file in case you'll use a different screw size.

In case you need the stl files individually, you can get them from the 3mf file.