proforge 5 filament dry box relocation
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
relocation of filament dry box
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 62
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Open Community License v1
i'm tired of long ptfe tubes. filament always breaking inside the tubes so i made this part to keep the ptfe tubes as short as i can
you need to drill a hole in the back side as shown in the picture (the lower hole)
remove the panel screw and mount the part using the upper hole then drill the lower hole using a 5.5mm drill bit
i used
2 m5x6mm for the front side
2 m5x10mm for the back side
2 m3 D4.2 heat insert
2 m3x25mm (you can use as long as you can cuz its open)
the heat inserts goes in the end connections for the front part ( see the screw at the picture)
insert the heat insert and then mount the parts ( front & back ) first and then connect them using m3 screws