proforge 5 filament dry box relocation

i'm tired of long ptfe tubes. filament always breaking inside the tubes so i made this part to keep the ptfe tubes as short as i can

you need to drill a hole in the back side as shown in the picture (the lower hole)

remove the panel screw and mount the part using the upper hole then drill the lower hole using a 5.5mm drill bit

i used

2 m5x6mm for the front side

2 m5x10mm for the back side

2 m3 D4.2 heat insert

2 m3x25mm (you can use as long as you can cuz its open)

the heat inserts goes in the end connections for the front part ( see the screw at the picture)

insert the heat insert and  then mount the parts ( front & back ) first and then connect them using m3 screws