Micro Air Turbine 100000 RPM
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
High-pressure micro axial turbine
- Rating
- 4 / 5
- Likes
- 11
- Downloads
- 51
- Makes
- 0
- Views
- 389
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial
GENERAL INFO
Designed for 5x8x2.5 mm bearings, M2x18 and M2x30 bolts with nuts for mounting.
For the shaft, it uses an M2x30 bolt, which makes the output shaft 15 mm long.
The intake outer diameter is 6 mm wide and 15 mm in length.
44mm long without the shaft.
18x23 perpendicular to the shaft.
PRINT
Print everything with a 0.1 mm layer height and with a randomized seam, except the intake. The turbine WILL NOT work without the randomized seam, because the bolt that acts as a shaft will be misaligned.
Print the turbine with PETG; PLA is not recommended; it needs to withstand high centrifugal forces and a lot of vibrations. You might also want to reduce the printing speed for the turbine.
ASSEMBLY
Before screwing in the turbine, you'll need to chamfer the cone-like hole on a turbine that connects both parts together. Don't overdo it; you just need to get rid of the excess plastic. You should first screw in the M2x30 bolt into the smaller shaft part of the turbine, followed by the turbine and a nut. You will need to sand the turbine a little bit, especially on the top-layer side. Insert the 5x8x2.5 mm bearings into the right holes; make sure that they are pushed all the way. You can now screw everything together with M2×18 bolts and secure them with nuts. It should easily spin without any resistance. If there is too much resistance, you might want to sand the turbine or the turbine housing a little bit until you get the desired results. If used with high pressure, it will grind itself anyway. If there are strong vibrations, you might want to check if your bearings are flat with the housing and the stator surfaces; there is also a possibility that the M2×30 bolt you used might not be perfectly straight. Look for a straight one. Also make sure you didn't forget about the randomized seam.
You can measure its rpm by measuring sound frequency, dividing the results by 12, and then multiplying it by 60.
The maximum rpm I've measured was over 100000 rpm.
The maximum torque I've measured was 4.44 g with a 10 cm lever on a stalled turbine, which calculates to 0.00435 N/m.
With 8 bars of pressure, it has around 50W of power.
It's enough to burn a hole in wood with friction alone.