Iwata Eclipse HP-CS Airbrush Nozzle Driver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For unscrewing or screwing the nozzle cap from an Iwata HP-CS airbrush.
- Rating
- 5 / 5
- Likes
- 32
- Downloads
- 172
- Makes
- 5
- Views
- 878
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
Iwata Eclipse HP-CS Nozzle Driver
For unscrewing or screwing the nozzle cap from an Iwata HP-CS airbrush but it should fit many other airbrushes (not tested).
The Driver can also be left on the airbrush as a dust cover.
The odd thing about the Iwata airbrush is that the nozzle is not a simple hexagonal section as you can see from the pics.
The supplied spanner from Iwata is fine - but it's metal and can easily slip and scratch your airbrush. This thing is plastic and won't. It's a perfect snug fit and will fasten or detach your nozzle with supreme ease and tension it just perfectly.
The downside - ain't none - no - whatsoever - nope - zero downsides. Why don't Iwata supply something like this with their (very expensive) airbrushes? Or other airbrush manufacturers? Answer - dunno. They should. Aztek were the only ones who did anything like that.
Ho hum - rant over.
The depth of the hollow end is such that it can be used with the needle cap on or off as long as you don't push it past where the nozzle cap meets the body of the airbrush. Possibly a conical extrusion inside the Driver would prevent any damage to a needle if used with the needle cap removed. I'll look into that…
Material: PLA
Layer height: 0.3 mm
Supports and brim: None
Regards, Paul