1 / 1
914 Top Trunk Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This part helps to hold the 914 targa top in the trunk.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 9
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This was created to replace the broken rubber holder for a 914 convertible lid. It was printed in TPU 95 using manufacturer recommended settings. The stainless steel bushing was purchased from a local hardware store, 6mm inner diameter. An area of solid infill was added in the area where the holder is pulled back when the lid is inserted, the remainder was set to Gyroid 20%. Permitiers was set to 4 for increased strength. This part was installed but not tested yet.