Pegasus Powerbox Advance Gen 2 Foot Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed for printing in resin and utility. Finder mount style foot that attaches to the bottom of PPAG2.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 50
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution — Noncommercial
Finder foot style mount for Pegasus Powerbox Advance Gen 2. Original design was adequate, but not optimized for printing in resin. After printing, snap off the braces in the pockets, they are only there to help prevent sagging/delamination during printing.
Mount and attachment models separated, .f3d file contains both. The attachment is designed to allow for use of 1/2" velcro bands for cable management, but is sturdy enough to use only a single post and extend further out for more options.
Attachment should slot easily into mount, maybe be less easy to remove.
With attachment and mount, M3-0.5x20 with or without an M3 washer will work. Mount only utilizes M3-0.5x8, slightly longer may also work.