No-Support 2-Piece Universal Soap, Sponge & Utensil Drainer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A clean, practical and easy-to-print drainer for everyday use in the bathroom or kitchen. Perfect for soap, sponges, ladles, spoons and other small utensils while cooking.
The design consists of only two simple parts and prints without supports. Unlike many drainers, it has no external drainage channel, so liquid stays inside the tray instead of leaving marks on your sink or countertop. Just lift the insert, empty the base, rinse, and it is clean again.
Simple, universal, elegant — and very easy to maintain.
Parts: 2
Supports: No supports required
Recommended material: PETG recommended for bathroom/kitchen use
Layer height: 0.20 mm
Walls: 3 perimeters
Infill: 10–15%
Orientation: Print both parts flat on the build plate
Approx. largest part size: 185 × 101 × 27 mm
Assembly: No hardware, no glue — just place the insert into the base