Stealthchanger Eddy Shuttle Mount

This is an btt eddy holder, meant for a stealtchanger, in order to use it i made a costum shuttle, its the normal one with 2 heat inserts in the back, to attach the eddy.

Then there is the Connector piece, which is basically just an extension, its just a long arm for the eddy, since it sadly doesnt fit unter the X Carriage Extrusion (with my setup, only having dragonburners with V6 hotend). And you need to match the Height of the holes for the heat inserts on the eddys side, to match the height offset from your nozzle.

While at it, I remodeld the Eddy Housing, so you can now make the Screws that hold it be flush,just to get a few more mms of print space and it has ziptie holders for the cable, its relativly hard to print, but doable without supports, split the Casing where the PCB is sticking out and just glue it together.

And there is an Helper to find the center of the eddy, just put some tape on the bottom, line it up with the eddy, and there is a hole in the middle where the nozzle belongs, so you can measure the xyz offsets.

PS: The shuttle CAD was edited pretty sloppy by me, will add photos later had to add a bad one cause too lazy rn